Allied Telesis AT-FS970M Series - Manual (Page 1677)

AT-FS970M Switch Command Line User’s Guide
1677
“POLICE SINGLE-RATE ACTION” on
page 1733 Policy Map
Class Configures a single-rate policer for a
class map.
“POLICE TWIN-RATE ACTION” on
page 1735 Policy Map
Class Create a twin-rate policer for a class
map.
“POLICY-MAP” on page 1737 Global
Configuration Creates a policy map and enters the
Policy Map Configuration mode.
“SET COS” on page 1738 Policy Map
Class Sets the CoS value of classified traffic.
“SET DSCP” on page 1740 Policy Map
Class Sets the DSCP value of classified
traffic.
“SET QUEUE” on page 1741 Policy Map
Class Sets the egress queue of the
classified traffic.
“SERVICE-POLICY INPUT” on
page 1743 Interface
Configuration Associates a policy map with an
interface.
“SHOW CLASS-MAP” on page 1744 User Exec and
Privileged Exec Displays a QoS class map.
“SHOW POLICY-MAP” on page 1745 User Exec and
Privileged Exec Displays a Policy map.
“SHOW MLS QOS” on page 1747 Privileged Exec Displays the status of QoS.
“SHOW MLS QOS AGGREGRATE-
POLICER” on page 1748 Privileged Exec Displays the aggregate policers
assigned on the switch.
“SHOW MLS QOS INTERFACE” on
page 1750 Privileged Exec Displays the scheduling methods of
the ports, and for Weighted Round-
Robin (WRR) based scheduling, the
assignments of weights to egress
queues.
“SHOW MLS QOS MAPS COS-
QUEUE” on page 1753 Privileged Exec Displays the mappings of CoS priority
values to egress queues.
“SHOW MLS QOS MAPS DSCP-
QUEUE” on page 1754 Privileged Exec Displays the mappings of DSCP
priority values to port egress queues.
“SHOW MLS QOS MAPS POLICED-
DSCP” on page 1757 Privileged Exec Displays the mappings of an existing
DSCP to a new DSCP value.
“TRUST DSCP” on page 1758 Policy Map
Class Enables the pre-mark DSCP map to
replace the bandwidth class, DSCP,
and queue of classified traffic.
Table 231. Quality of Service Commands (Continued)
Command Mode Description