Allied Telesis AT-FS970M Series - Manual (Page 508)

Chapter 30: Group Link Control Commands
508
NO GROUP-LINK-CONTROL
Syntax
no group-link-control group_id
Parameters
group_id
Specifies the ID number of the group to be deleted. The range is 1
through 8. You can delete only one group at a time.
Mode
Global Configuration mode
Description
Use this command to delete groups from group link control.
Note
Downstream ports that group link control has disabled remain
disabled even after a group is deleted. To manually activate them,
use the NO SHUTDOWN command. For instructions, refer to
“Enabling or Disabling Ports” on page 184 or “NO SHUTDOWN” on
page 219.
Confirmation Command
“SHOW GROUP-LINK-CONTROL” on page 511
Example
This example deletes the group with ID 2:
awplus> enable
awplus# configure terminal
awplus(config)# no group-link-control 2