Ip rip send-packet 3, Ip rip send-packet – Allied Telesis AT-FS970M Series User Manual

Page 1853

Text mode
Original mode

AT-FS970M Switch Command Line User’s Guide

1853

IP RIP SEND-PACKET

Syntax

ip rip send packet

Parameters

None

Mode

VLAN Interface mode

Description

Use this command to enable the routing interfaces in VLANs to send
routing updates. You can configure only one routing interface at a time
with this command.

Confirmation Command

“SHOW RUNNING-CONFIG” on page 166

Example

The following example configures the routing interface in VLAN 3 to send
routing updates:

awplus> enable
awplus# configure terminal
awplus(config)# interface vlan3
awplus(config-if)# ip rip send-packet