beautypg.com

Ip rip receive-packet 0, Ip rip receive-packet – Allied Telesis AT-FS970M Series User Manual

Page 1850

background image

Chapter 105: Routing Information Protocol (RIP) Commands

1850

IP RIP RECEIVE-PACKET

Syntax

ip rip receive-packet

Parameters

None

Mode

VLAN Interface mode

Description

Use this command to enable the routing interfaces to receive routing
updates. By default, the receive-packet is enabled. You can configure only
one routing interface at a time with this command.

Confirmation Command

“SHOW RUNNING-CONFIG” on page 166

Example

The following example configures the routing interface in VLAN 3 to
accept routing updates:

awplus> enable
awplus# configure terminal
awplus(config)# interface vlan3
awplus(config-if)# ip rip receive-packet