Allied Telesis AT-FS970M Series - Manual (Page 866)

Chapter 57: MSTP Commands
866
SPANNING-TREE ERRDISABLE-TIMEOUT INTERVAL
Syntax
spanning-tree errdisable-timeout interval interval
Parameters
interval
Specifies the number of seconds that ports remain disabled by the
BPDU guard feature. The range is 10 to 1000000 seconds. The
default is 300 seconds.
Mode
Global Configuration mode
Description
Use this command to specify the number of seconds that must elapse
before the switch automatically enables ports that are disabled by the
BPDU guard feature. To activate the timer, refer to “SPANNING-TREE
ERRDISABLE-TIMEOUT ENABLE” on page 865.
To reset the timer to its default value of 300 seconds, use the NO
SPANNING-TREE ERRDISABLE-TIMEOUT INTERVAL command.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 166
Example
This example sets the time interval to 200 seconds:
awplus> enable
awplus# configure terminal
awplus(config)# spanning-tree errdisable-timeout interval
200