Allied Telesis AT-FS970M Series - Manual (Page 1675)

1675
Chapter 99
Quality of Service (QoS) Commands
The Quality of Service (QoS) commands are summarized in Table 231
and described in detail in this chapter.
Table 231. Quality of Service Commands
Command Mode Description
“AUTO-QOS” on page 1679 Interface
Configuration Enables Auto-QoS support for a voice
VLAN and specifies CoS or DSCP
trusted traffic.
“AUTO-QOS-MED” on page 1681 Global
Configuration Enables Auto-QoS-MED support for a
voice VLAN and specifies CoS or
DSCP trusted traffic.
“CLASS” on page 1683 Policy Map
Configuration Associates an existing class map to a
policy map and enters the Policy Map
Class Configuration mode.
“CLASS-MAP” on page 1685 Global
Configuration Creates a class map and enters the
Configuration Class Map mode.
“DEFAULT-ACTION” on page 1686 Policy Map Sets the action for the default class
map belonging to a particular policy
map.
“DESCRIPTION (Policy Map)” on
page 1688 Policy Map Adds a description of the policy map.
“MATCH ACCESS-GROUP” on
page 1690 Class Map Defines a group name as a match
criterion for a class map.
“MATCH COS” on page 1693 Class Map Sets the Class of Service (CoS) for a
class map to match with.
“MATCH DSCP” on page 1695 Class Map Defines DSCP to match incoming
packets.
“MATCH IP-PRECEDENCE” on
page 1696 Class Map Identifies IP precedence values as
match criteria.
“MATCH MAC-TYPE” on page 1697 Class Map Sets the MAC type for a class map.
“MATCH PROTOCOL” on page 1699 Class Map Sets the Ethernet format and protocol
for a class map.