Allied Telesis AT-FS970M Series - Manual (Page 1114)

Chapter 70: 802.1x Port-based Network Access Control Commands
1114
SHOW DOT1X INTERFACE
Syntax
show dot1x interface port
Parameters
port
Specifies a port. You can display more than one port at a time.
Modes
Privileged Exec mode
Description
Use this command to display the parameter settings of authenticator ports.
This command is equivalent to “SHOW AUTH-MAC INTERFACE” on
page 1109.
Figure 195 displays an example of the information.
Figure 195. SHOW DOT1X INTERFACE Command
Example
The example displays the authenticator parameter settings for ports 1.0.1
to 1.0.4:
awplus> enable
awplus# show dot1x interface port1.0.1-port1.0.4
Authentication Info for interface port1.0.2
portEnabled: Enabled - portControl: Auto
portStatus: UP
reAuthenticate: Enabled
reAuthPeriod: 3600
PAE: quietPeriod: 60 - maxReauthReq: 2 - txPeriod: 30
BE: suppTimeout: 30 - serverTimeout: 30
CD: adminControlledDirections: both
guestVlan: Enabled
DynamicVlanCreation: None
hostMode: Single-Host
dot1x: Enabled
protocolVersion: 1
authMac: Disabled
reAuthRelearning: Disabled