Allied Telesis AT-FS970M Series - Manual (Page 1115)

AT-FS970M Switch Command Line User’s Guide
1115
SHOW DOT1X STATISTICS INTERFACE
Syntax
show dot1x statistics interface port
Parameters
port
Specifies a port. You can enter more than one port.
Mode
Privileged Exec mode
Description
Use this command to display EAP packet statistics of authenticator ports.
This command is equivalent to “SHOW AUTH-MAC STATISTICS
INTERFACE” on page 1111. An example is shown in Figure 196.
Figure 196. SHOW DOT1X STATISTICS INTERFACE Command
Example
This example displays the EAP packet statistics for authenticator port
1.0.7:
awplus> enable
awplus# show dot1x statistics interface port1.0.7
Authentication Statistics for interface port1.0.2
EAPOL Frames Rx: 0 - EAPOL Frames Tx: 0
EAPOL Start Frames Rx: 0 - EAPOL Logoff Frames Rx: 0
EAP Rsp/Id Frames Rx: 0 - EAP Response Frames Rx: 0
EAP Req/Id Frames Tx: 0 - EAP Request Frames Tx: 0
Invalid EAPOL Frames Rx: 0 - EAP Length Error Frames Rx: 0
EAPOL Last Frame Version Rx: 0 - EAPOL Last Frame Src: 0000.0000.0000