Allied Telesis AT-FS970M Series - Manual (Page 1195)

1195
Chapter 75
sFlow Agent Commands
The sFlow agent commands are summarized in Table 118 and described
in detail within the chapter.
Table 118. sFlow Agent Commands
Command Mode Description
“NO SFLOW COLLECTOR IP” on
page 1196 Global
Configuration Deletes the IP address of an sFlow
collector from the switch.
“NO SFLOW ENABLE” on page 1197 Global
Configuration Disables the sFlow agent on the
switch.
“SFLOW COLLECTOR IP” on
page 1198 Global
Configuration Adds the IP addresses and UDP ports
of sFlow collectors on your network to
the sFlow agent on the switch.
“SFLOW ENABLE” on page 1199 Global
Configuration Activates the sFlow agent on the
switch.
“SFLOW POLLING-INTERVAL” on
page 1200 Port Interface Sets the polling intervals that control
the maximum amount of time
permitted between successive
pollings of the port packet counters by
the sFlow agent.
“SFLOW SAMPLING-RATE” on
page 1202 Port Interface Sets the sampling rates that
determine the number of ingress
packets from which one sample is
taken on a port.
“SHOW SFLOW” on page 1204 Global
Configuration Displays the IP addresses and the
UDP ports of the sFlow collectors.
Also displays the sampling and polling
values for the individual ports.