Allied Telesis AT-FS970M Series - Manual (Page 1706)

Chapter 99: Quality of Service (QoS) Commands
1706
MATCH VLAN
Syntax
match vlan < 1-4094 >
Parameters
1-4094
Specifies the VLAN ID number.
Mode
Class Map Configuration mode
Description
Use this command to add the specified VLAN ID as a matching criteria
within a class map. This value is used to match incoming packets.
Use the no form of the command, NO MATCH VLAN, to remove the VLAN
ID from the class map.
Confirmation Command
“SHOW CLASS-MAP” on page 1744
“SHOW RUNNING-CONFIG” on page 166
Examples
The following example configures a class map called “cmap3” to include
traffic from VLAN 5:
awplus> enable
awplus# configure terminal
awplus(config)# class-map cmap3
awplus(config-cmap)# match vlan 5
The following example disables the configured VLAN ID as a match
criteria for class map “cmap3:”
awplus> enable
awplus# configure terminal
awplus(config)# class-map cmap3
awplus(config-cmap)# no match vlan