Allied Telesis AT-FS970M Series - Manual (Page 615)

AT-FS970M Switch Command Line User’s Guide
615
SHOW IP IGMP INTERFACE
Syntax
show ip igmp interface vlanid
Parameters
vlanid
Specifies a VLAN ID, for example, “vlan3.” You may specify only
one VLAN.
Mode
Privileged Exec mode
Description
Use this command to display the status of IGMP snooping querier on the
VLANs. Here is an example of the display:
Figure 119. SHOW IP IGMP INTERFACE Command
Note
This command does not display information about multiple queriers.
The fields are defined in Table 68.
Table 68. SHOW IP IGMP INTERFACE Command
Field Definition
Interface The ID number of the selected VLAN.
IGMP The status of the IGMP agent. The agent is
automatically enabled when IGMP snooping
querier is activated.
IGMP query
interval The time interval in seconds at which IGMP
General Query messages are transmitted.
Interface vlan1 (Index 0)
IGMP Enabled, Active, Version 2
IGMP query interval is 125 seconds
IGMP Snooping is globally enabled
IGMP Snooping querier is enabled