Allied Telesis AT-FS970M Series - Manual (Page 1843)

1843
Chapter 105
Routing Information Protocol (RIP)
Commands
The RIP commands are summarized in Table 256 and described in detail
within the chapter.
Table 256. RIP Commands
Command Mode Description
“AUTO-SUMMARY” on page 1846 Routing
Configuration Activates automatic route
summarization.
“DEFAULT-INFORMATION
ORIGINATE” on page 1847 Routing
Configuration Configures the switch to send its
default route from the RIP-enabled
routing interfaces.
“IP RIP AUTHENTICATION STRING”
on page 1848 VLAN Interface Specifies an authentication key or
password that a routing interface uses
to authenticate the routing updates.
“IP RIP AUTHENTICATION MODE”
on page 1849 VLAN Interface Specifies the MD5 or plain-text
authentication mode for an
authentication key or password on a
routing interface.
“IP RIP RECEIVE-PACKET” on
page 1850 VLAN Interface Enables the VLAN interface to receive
routing updates.
“IP RIP RECEIVE VERSION” on
page 1851 VLAN Interface Specifies the version of routing
updates accepted on the VLAN
interface.
“IP RIP SEND-PACKET” on
page 1853 VLAN Interface Enables the VLAN to send routing
updates.
“IP RIP SEND VERSION” on
page 1854 VLAN Interface Specifies the version of routing
updates that the VLAN interface
sends.
“IP RIP SPLIT-HORIZON” on
page 1855 VLAN Interface Activates split-horizon or split-horizon
with poison reverse on the routing
interfaces.
“NETWORK” on page 1857 Routing
Configuration Specifies a network or VLAN to allow
the interface to send and accept
routing updates.