Adding target disk luns for encryption – Brocade Network Advisor SAN User Manual v12.3.0 User Manual
Page 874
822
Brocade Network Advisor SAN User Manual
53-1003154-01
Adding target disk LUNs for encryption
20
Adding target disk LUNs for encryption
You can add a new path to an existing disk LUN or add a new LUN and path by launching the Add
New Path wizard.
NOTE
Before you can add a target disk LUN for encryption, you must first configure the Storage Arrays. For
more information, see
Complete the following steps to add a target disk LUN:
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box.
2. Select a group, switch, or engine from the Encryption Center Devices table, then select
Group/Switch/Engine > Disk LUNs from the menu task bar.
The Encryption Disk LUN View dialog box displays. (Refer to
FIGURE 378
Encryption Disk LUN View dialog box
The dialog box provides a convenient way to view and manage disk LUNs that are provisioned
from different hosts, identify conflicts between configuration policies on storage systems, and
to provide a launching point for the Add New Path wizard for configuring multiple I/O paths to
the LUN.
The dialog box contains the following information:
•
Storage Array
selector: Determines which LUN paths are displayed in the table. Enables
you to select a storage array from the LUN view prior to launching the Add New Path
wizard. Only ports that belong to at least one target container are listed.
•
Host selector: Used to select a host from the LUN view prior to launching the Add New Path
wizard. Only ports that belong to at least one target container are listed.