Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 1105)

Brocade Network Advisor SAN User Manual 1053
53-1003154-01
Chapter
27
Fibre Channel Troubleshooting
In this chapter
• FC troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1053
• FCIP troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1062
FC troubleshooting
NOTE
FC troubleshooting is only available for Fabric OS devices.
You can perform the following operations using FC troubleshooting:
• Trace Route (Path Information and FC Ping) – Use to obtain the detailed routing information for
any two selected device ports. The devices can exist in the same fabric or in two different
fabrics shared through FC Routers.
• Device Connectivity Troubleshooting – Use to identify any problems that might be preventing
communication between the two selected device ports. The device ports can be selected from
the same fabric or from two different fabrics.
• Fabric Device Sharing Diagnosis (pure Fabric OS fabrics only) – Use to confirm that any two or
more selected fabrics are capable of sharing devices between them.
• Diagnostic Port Testing (Fabric OS 10 Gbps-capable and 16 Gbps-capable ports only) – Use to
run the following diagnostic port tests on the 10 Gbps-capable and 16 Gbps-capable ports:
electrical (16 Gbps only), optical (16 Gbps only), measure link distance, and link traffic.