Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 836)

784 Brocade Network Advisor SAN User Manual
53-1003154-01
Creating a new encryption group
20
After configuration of the encryption group is completed, the Management application sends
API commands to verify the switch configuration. See
“Understanding configuration status
results” on page 800 for more information.
11. Review important messages, then click Next.
The Next Steps dialog box displays. (Refer to Figure 337 .) Instructions for installing public key
certificates for the encryption switch are displayed.
FIGURE 337 Next Steps dialog box
12. Review post-configuration instructions, which you can copy to a clipboard or print for later.
13. Click Finish to exit the Configure Switch Encryption wizard.
14. Refer to “Understanding configuration status results” on page 800.
Configuring key vault settings for Thales e_Security keyAuthority (TEKA)
The following procedure assumes you have already configured the initial steps in the Configure
Switch Encryption wizard. If you have not already done so, go to
“Creating a new encryption group”
on page 764.
Figure 338 shows the key vault selection dialog box for TEKA.