Brocade Network Advisor SAN User Manual v12.3.0 User Manual
Page 488
436
Brocade Network Advisor SAN User Manual
53-1003154-01
AAA Settings tab
11
FIGURE 179
AAA Settings tab - LDAP server
3. Add or edit an LDAP server by referring to
The LDAP Servers and Sequence table displays the following information:
•
Network Address — The network address of the LDAP server.
•
Authentication Type — The authentication type (such as CHAP).
•
Security — Whether or not security is enabled.
•
TCP Port — The TCP port number of the LDAP server.
•
TimeOut (Sec) — The timeout value in seconds specified when sending an authentication
request to the server. Default is 3.
•
Attempts — The number of attempts made to reach a server before determining it is
unreachable. Default is 3.
NOTE
You can add any number of LDAP servers to the configuration.
4. Rearrange the LDAP servers in the table by selecting a server and clicking the Up or Down
button to move it.
5. Delete a LDAP server by selecting the server and clicking Delete.
6. Test the established active connection with the LDAP server by clicking Test.
The Test Authentication dialog box displays.
7. Enter your user name and password and click OK.
Test attempts to contact the LDAP server by issuing a ping command and verifies the following:
•
Verifies connections to the LDAP Server
•
Verifies authentication with the LDAP Server
•
Verifies user privileges on the Local database
8. Set secondary authentication by selecting one of the following options from the Secondary
Authentication list:
•
Local Database
•
None
9. Set the fall back condition to secondary authentication by selecting one of the following
options from the Switch to secondary authentication when list: