Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 1445)

Brocade Network Advisor SAN User Manual 1393
53-1003154-01
Upload failure data capture
34
• Location — The customer site location.
• Contact — The primary contact at the customer site.
• Description — A description of the customer site.
• State — The switch state, for example, online or offline.
• Status — The operational status of the switch, for example, unknown or marginal.
3. Click the right arrow button.
The selected devices move from the Available Switches with Upload Failure Data Capture
Disabled table to the Switches with Upload Failure Data Capture Enabled table.
The Switches with Upload Failure Data Capture Enabled table displays the following
information:
• IP Address — The switch’s IP address.
• Name — The name of the switch.
• FTP Host — The current FTP host configured on the switch.
• FTP Host Status — The status of the FTP host configured on the switch.
• FTP User — The user for the current FTP host configured on the switch.
• FTP Root — The root location where failure data capture files are saved.
4. Click OK on the Upload Failure Data Capture dialog box.
5. Click OK on the confirmation message, if necessary.
Disabling upload failure data capture
NOTE
Upload Failure Data Capture is only supported on Fabric OS devices.
1. Select Monitor > Technical Support > Upload Failure Data Capture.
The Upload Failure Data Capture dialog box displays.
2. Select one or more devices on which you want to disable automatic trace dump from the
Available Switches with Upload Failure Data Capture Enabled table.
3. Click the left arrow button.
The selected devices move from the Switches with Upload Failure Data Capture Enabled table
to the Available Switches with Upload Failure Data Capture Disabled table.
4. Click OK on the Upload Failure Data Capture dialog box.
5. Click OK on the confirmation message, if necessary.