Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 681)

Brocade Network Advisor SAN User Manual 629
53-1003154-01
VLAN classifier configuration
16
Adding a VLAN classifier rule
The Edit Switch dialog box, VLAN Classifiers tab allows you to create rules and group them into
VLAN classifiers, which can then be applied to access port and LAG VLAN members and converged
port VLAN members.
1. Select Configure > DCB.
The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and
functions.
2. Select a switch and click Edit.
3. Click the VLAN Classifiers tab on the Edit Switch dialog box.
The Edit Switch dialog box, VLAN Classifiers tab displays, as shown in Figure 239 . The
Available Rules list contains the following information:
• Rule ID — The rule identifier. Valid rule ID values are from 1 through 256.
• Rule Type — Valid rule types are MAC (MAC address-based rule) and Proto (802.1Q
protocol-based rule).
• Encapsulation — The encapsulation type (Ethv2, nosnaplic, or snaplic). The Encapsulation
column only displays a value when Proto is the rule type.
FIGURE 239 Edit Switch dialog box, VLAN Classifiers tab
4. Click the Add button under the Available Rules list.
The Add Rules dialog box displays, as shown in Figure 240 .