Brocade Network Advisor SAN User Manual v12.3.0 User Manual
Page 822
770
Brocade Network Advisor SAN User Manual
53-1003154-01
Creating a new encryption group
20
1. Enter the IP address or host name for the primary key vault. If you are clustering DPM
appliances for high availability, IP load balancers are used to direct traffic to the appliances.
Use the IP address of the load balancer.
2. Enter the name of the file that holds the Primary Key Vault’s CA Key Certificate or browse to the
desired location. This file can be generated from the key vault’s administrative console.
3. If you are implementing encryption on data replication LUNs used by the EMC Symmetrix
Remote Data Facility (SRDF), you must select Enabled for REPL Support.
4. Click Next.
The Specify Certificate Signing Request File Name dialog box displays. (Refer to
.)
FIGURE 319
Specify Certificate Signing Request File Name dialog box
5. Enter the filename in which you want to store the certificate information, or browse to the file
location.
The certificate stored in this file is the switch’s Switch Certificate Signing file. You will need to
know this path and file name to install the switch’s Switch Certificate Signing file on the key
management appliance.
6. Click Next.
The Specify Master Key File Name dialog box displays. (Refer to