Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 1389)

Brocade Network Advisor SAN User Manual 1337
53-1003154-01
MAPS monitoring categories
33
MAPS monitoring categories
MAPS enables you to monitor the independent components that are listed in this section by
creating policies. Policies are a series of rules that define thresholds for measures and actions to
take when a threshold is triggered.
Port monitoring category
The Port category monitors port statistics and takes action based on the configured thresholds and
actions. You can configure thresholds per port type and apply the configuration to all ports of the
specified type. Configurable ports include physical ports, E_Ports, optical F_Ports (FOP_Ports),
copper F_Ports (FCU_Ports), and Virtual E_Ports (VE_Ports).
The Port category also monitors the physical aspects of an SFP transceiver, such as voltage,
current, RXP, TXP, and state changes in physical ports, E_Ports, FOP_Ports, and FCU_Ports.
Table 111 lists measures in the Port category and describes each measure.
FCIP Circuit
•
CIR_STATE — FCIP circuit state changes
•
CIR_UTIL — FCIP circuit utilization
•
CIR_PKTLOSS — FCIP packet loss
•
PKTLOSS — FCIP tunnel packet loss 3
•
RTT — Round-trip time of the circuit
•
Jitter — The variance in round-trip time of the circuit
•
TUNNEL_UTIL — Tunnel utilization
•
TUNNEL_STATE — FCIP tunnel status
•
RAS Log Event
•
Fence (CIR_STATE)
•
SNMP Trap
•
E-mail
Traffic /
Flows
Performance FC Port
•
RX — Receive bandwidth usage percentage
•
TX — Transmit bandwidth usage percentage
•
UTIL — Trunk utilization
•
RAS Log Event
•
SNMP Trap
•
E-mail
Flow
•
TX_FCNT — Tx Frame Count
•
RX_FCNT — Rx Frame Count
•
TX_THPUT — Tx Throughput
•
RX_THPUT — Rx Throughput
•
IO_RD — IO Read Command Count
•
IO_WR — IO Write Command Count
•
IO_RD_BYTES — IO Read Data
•
IO_WR__BY_TES — IO Write Data
FPI FC Port
•
DEV_LATENCY_IMPACT — Device latency Impact
•
RAS Log Event
•
SNMP Trap
•
E-mail
1. Only valid for 16 Gbps, 10 Gbps, and QSFP transceivers.
2. For FLASH_USAGE, you can configure RAS Log Event, Fence, SNMP Trap, E-mail, Switch Status Critical, or Switch Status Marginal.
3. Supported only on the Brocade 7840.
TABLE 110 Monitors and actions by category (Continued)
Category Objects Measures Possible actions