Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 821)

Brocade Network Advisor SAN User Manual 769
53-1003154-01
Creating a new encryption group
20
8. Select the Key Vault Type. Configuration options vary based on the key vault type you choose.
To complete the wizard steps, proceed to the section that describes your particular key vault
type.
- For DPM key vault setting instructions, see “Configuring key vault settings for RSA Data
Protection Manager (DPM)” on page 769.
- For LKM/SSKM key vault setting instructions, see “Configuring key vault settings for
NetApp Link Key Manager (LKM/SSKM)” on page 774.
- For ESKM/SKM key vault setting instructions, see “Configuring key vault settings for HP
Enterprise Secure Key Manager (ESKM/SKM)” on page 780.
- For TEKA key vault setting instructions, see “Configuring key vault settings for Thales
e_Security keyAuthority (TEKA)” on page 784.
- For TKLM key vault setting instructions, see “Configuring key vault settings for IBM Tivoli
Key Lifetime Manager (TKLM)” on page 789.
- For KMIP key vault setting instructions, see “Configuring key vault settings for Key
Management Interoperability Protocol” on page 794.
Configuring key vault settings for RSA Data Protection Manager (DPM)
The following procedure assumes you have already configured the initial steps in the Configure
Switch Encryption wizard. If you have not already done so, go to
“Creating a new encryption group”
on page 764.
Figure 318 shows the key vault selection dialog box for DPM.
FIGURE 318 Select Key Vault dialog box for DPM