Supported port configurations for each feature, Notes on supported configurations – Brocade Network Advisor SAN User Manual v12.3.0 User Manual
Page 1182

1130
Brocade Network Advisor SAN User Manual
53-1003154-01
Flow Vision flows
29
Supported port configurations for each feature
lists the supported configurations for each Flow Vision feature using only the basic flow
parameters (ingress port and source device, egress port and destination device).
Notes on supported configurations
•
If you are using at least one advanced parameter (LUN, frame type, or bidirectional), then
feature-specific rules apply. Refer to the individual Flow Vision features for specific details.
•
Neither ranges nor lists are supported for any parameter.
scsi2reserve
Only SCSI 2 reserve command frames
scsi3reserve
Only SCSI 3 reserve command frames
scsi2release
Only SCSI 2 release command frames
scsi3release
Only SCSI 3 release command frames
scsiresrel2
Only SCSI 2 reserve-release command frames
scsiresrel3
Only SCSI 3 reserve-release command frames
scsitur
Only SCSI test unit ready frames
scsicmdsts
Only SCSI command status frames
NOTE: This parameter is valid only for Flow Mirror. It implicitly assumes bidirectional flow
and looks for both SCSI command and status frames.
scsigoodstatus
Only SCSI status frames with status marked as good (all 0s (zeros) in status byte)
scsicheckstatus
Only SCSI status frames with check status (Check Condition, Busy, Reservation Conflict,
Task Full Set)
scsiinquiry
Only SCSI inquiry frames
scsiresvconflict
Only SCSI status frames with reservation conflict set
scsixferrdy
Only SCSI FCP XFER_RDY (transfer ready) frames
TABLE 90
Port configurations supported in Flow Vision
Feature
Platforms
Switch Configuration Mode
16 Gbps-capable
Fibre Channel
1
1.
16 Gbps-capable platforms include the FC8-32E and FC8-48E blades.
8 Gbps-capable
Fibre Channel
Access Gateway
Virtual Fabric
Flow Monitor
Supported
(E_Ports, EX_Ports,
F_Ports, and
XISL_Ports)
Supported
(E_Ports, EX_Ports,
F_Ports, and
XISL_Ports)
Supported
(F_Ports only)
Supported
Flow Generator
Supported
(SIM-Ports only)
Supported (Destination
SIM-Ports only)
Not Supported
Supported
Flow Mirror
Supported (F_Ports and
F_Port trunks)
Not Supported
Not Supported
Supported
TABLE 89
Supported frame type parameters (Continued)
Frame type parameter Frames counted