Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 98)

84 Brocade Mobility RFS7000-GR Controller System Reference Guide
53-1001944-01
Viewing and configuring Layer 2 virtual LANs
4
NOTE
For Adaptive AP to work properly with Brocade Mobility RFS7000-GR Controller you need to have
independent and extended WLANs mapped to a different VLAN than the ge port.
3. Select a record from the table and click the Edit button to modify the record. For more
information, see “Editing the details of an existing VLAN by port” on page 84.
Editing the details of an existing VLAN by port
To revise the configuration of an existing VLAN:
1. Select Network > Virtual LANs from the main menu tree.
2. Select an Ethernet for which you want to configure the VLAN and click on the Edit button.
The system prompts you with a Port VLAN Change Warning message stating communication
disruptions could occur with the switch.
3. Click OK to continue.
4. Use the Edit screen to modify the VLAN’s mode, access VLAN and allowed VLAN designation.