Viewing and configuring port instance details – Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) User Manual
Page 242
228
Brocade Mobility RFS7000-GR Controller System Reference Guide
53-1001944-01
Multiple spanning tree
4
2. Click on OK button to save and commit the new configuration.
3. Click Cancel to disregard the changes and revert back to the previous configuration.
Viewing and configuring port instance details
Use the Port Instance tab to view and configure MST parameters per port per instance, including
Port Priority and Admin Internal Path Cost.
To view and configure the MSTP bridge instance:
Port FastBPDU Guard
Enable this option to change the status of the Port Fast BPDU Guard.
Port Version
Select a value to reconfigure the port version.
Port Path Cost
Port Path Cost Displays the path cost for the specified port index. The default path
cost depends on the speed of the interface.
Speed Default path cost
<=100000 bits/sec 200000000
<=1000000 bits/sec 20000000
<=10000000 bits/sec 2000000
<=100000000 bits/sec 200000
<=1000000000 bits/sec 20000
<=10000000000 bits/sec 2000
<=100000000000 bits/sec 200
<=1000000000000 bits/sec 20
>1000000000000 bits/sec 2
Admin Point-to-Point
status
Define the point-to-point status as ForceTrue or ForceFalse. ForceTrue indicates
this port should be treated as connected to a point-to-point link. ForceFalse
indicates this port should be treated as having a shared connection. A port
connected to a hub is on a shared link, while one connected to a switch or
workstation is a point-to-point link.
Port Enable
Select this checkbox to use this port for the forwarding of packets on the switch.
Port Migration
The switch can interoperate with legacy 802.1d bridges running STP / RSTP. If the
port receives a legacy 802.1D configuration BPDU, it only sends 802.1D BPDUs
over its port from that point on. Enable this option to restart detection of whether
the port is connected to an MSTP capable bridge or a legacy 802.1 bridge.
Admin Edge Port
Select the checkbox to define this port as an admin edge port.