Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) User Manual
Page 465
Brocade Mobility RFS7000-GR Controller System Reference Guide
451
53-1001944-01
Configuring SNMP Traps
7
1. Select Management Access > SNMP Trap Configuration from the main menu tree.
2. Click the Wireless Statistics Thresholds tab.
3. Refer to the following information for thresholds descriptions, conditions, editable threshold
values and units of measurement.
Threshold Name
(Description)
Displays the target metric for the data displayed to the right of the item. It defines a
performance criteria used as a target for trap configuration.
Threshold Conditions
Displays the criteria used for generating a trap for the specific event. The Threshold
conditions appear as greater than, less then or worse then and define a baseline
for trap generation.
Threshold values for:
MU
Displays a threshold value for associated MUs. Use the Threshold Name and
Threshold Conditions as input criteria to define an appropriate Threshold Value
unique to the MUs within the network. For information on specific values, see
“Wireless trap threshold values”
Threshold values for: AP
Set a threshold value for adopted APs. Use the Threshold Name and Threshold
Conditions as input criteria to define an appropriate Threshold Value unique to the
APs within the network. For information on specific values, see
Threshold values for:
WLAN
Use the Threshold Name and Threshold Conditions as input criteria to define an
appropriate Threshold Value unique to the switch. For information on specific
values, see
“Wireless trap threshold values”
Threshold values for:
Switch
Use the Threshold Name and Threshold Conditions as input criteria to define an
appropriate Threshold Value unique to the switch. For information on specific
values, see
“Wireless trap threshold values”
Unit of Threshold
Values
Displays the measurement value used to define whether a threshold value has
been exceeded. Typical values include Mbps, retries and %. For information on
specific values, see