Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 89)

Brocade Mobility RFS7000-GR Controller System Reference Guide 75
53-1001944-01
Chapter
4
Network Setup
In this chapter
This chapter describes the Network Setup menu information used to configure the switch. This
chapter consists of the following switch Network configuration activities:
• Displaying the network interface
• Viewing network IP information
• Viewing and configuring Layer 2 virtual LANs
• Configuring switch virtual interfaces
• Viewing and configuring switch WLANs
• Viewing associated MU details
• Viewing Access Port Information
• Viewing access port adoption defaults
• Viewing adopted access ports
• IGMP Snooping
NOTE
HTTPS must be enabled to access the switch applet. Ensure HTTPS access has been enabled before
using the login screen to access the switch applet.
Displaying the network interface
The main Network interface displays a high-level overview of the configuration (default or
otherwise) as defined within the Network main menu. Use the information to determine if items
require additional configuration using the sub-menu items under the main Network menu item.
NOTE
When the switch’s configuration is successfully updated (using the Web UI), the effected screen is
closed without informing the user their change was successful. However, if an error were to occur,
the error displays within the effected screen’s Status field and the screen remains displayed. In the
case of file transfer operations, the transfer screen remains open during the transfer operation and
remains open upon completion (with status displayed within the Status field).
To view the switch’s Network configuration: