Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) User Manual
Page 455
Brocade Mobility RFS7000-GR Controller System Reference Guide
441
53-1001944-01
Configuring Access Control
7
1. Select Management Access > Access Control from the main menu tree.
2. Refer to the Management Settings field to enable or disable the following switch interfaces:
Secure Management
(on Management VLAN
only)
Select this checkbox to allow management VLAN access to switch resources. The
management VLAN is used to establish an IP connection to the switch from a
workstation connected to a port in the VLAN. By default, the active management
VLAN is VLAN 1, but you can designate any VLAN as the management VLAN. Only
one management VLAN can be active at a time. This option is disabled (not
selected) by default.
Enable SNMPv3
Select the checkbox to enable SNMPv3 access to the switch over the SNMPv3
interface. This setting is enabled by default.
Retries
Define the number of retries the switch uses to connect to the SNMP interface if
the first attempt fails. The default value is 3 retry attempts.
Timeout
When the provided interval is exceeded, the user is logged out of the SNMP
session and forced re-initiate their connection. The default value is 10 minutes.
Enable HTTPS
Select this checkbox to enable HTTPS access to the switch. This setting is enabled
by default.
HTTPS Trustpoint
Use the Trustpoint drop-down menu to select the“default-trustpoint” used with a
HTTPS session with the switch. For information on creating a new certificate, see
“Creating server certificates”
Enable SSHv2
Select this checkbox to enable SSH version 2 access to the switch. Secure Shell
(SSH) is a program designed to perform a number of functions, such as file
transfer between computers, command execution or logging on to a computer over
a network. It is intended to do these tasks with greater security than programs
such as Telnet or FTP. This setting is enabled by default.
Port
Define the port number used for the SSH session with the switch.
RSA Key Pair
Use the RSA Key Pair drop-down menu to select a public/private key pair used for
RSA authentication. The default setting is “default_ssh_rsa_key”.