Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 318)

304 Brocade Mobility RFS7000-GR Controller System Reference Guide
53-1001944-01
Locationing
5
8. To use the onboard SOLE engine to locate Aeroscout tags check the Enable checkbox. This is
enabled immediately after checking the box.
9. If the onboard SOLE engine is enabled to locate Aeroscout tags, enter a Locate Interval in
seconds to specify how often the known tags are located by the SOLE engine.
10. Click the Apply button to save the Locate Interval value.
11. Click the Revert button to cancel any changes made within Locate Interval value and revert
back to the last saved configuration.
If the onboard SOLE engine is enabled to locate Aeroscout tags the following information will be
displayed for each located MU:
NOTE
Zone configuration can be defined using the CLI interface only. For information on Zone
Configuration please see the Brocade Mobility RFS7000-GR Controller CLI Reference Guide.
Configuring Ekahau parameters
To configure the switch to work with an external Ekahau RTLS engine:
Last Msg RX Time Displays the Date and Time that the last message was received from the external
Aeroscout RTLS engine.
No. of TX Msgs Displays the number of messages transmitted by the switch to the external
Aeroscout RTLS engine.
Last Msg TX Time Displays the Date and Time that the last message was sent to the external
Aeroscout RTLS engine.
No. of Tag Reports Displays the number of Tag Reports received from the external Aeroscout RTLS
engine.
MAC Lists the MAC Addresses of all MUs which have been located by the switch.
Location:
X Coordinate Displays the value of the X Coordinate for each located MU. The X coordinate is
relative to the origin point of 0,0 in the upper left corner of the site map.
Location:
Y Coordinate Displays the value of the Y Coordinate for each located MU. The X coordinate is
relative to the origin point of 0,0 in the upper left corner of the site map.
Timestamp Displays the last time for each MU that its location was computed by the switch.
Zone Lists the last known zone for each located MU. Zone configuration can be defined
using the CLI interface only. When no zones are configured, the switch defaults the
entire site to Zone 0.