Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 495)

Brocade Mobility RFS7000-GR Controller System Reference Guide 481
53-1001944-01
Configuring a ping
8
The What Kinds of messages should be seen field allows you to select a range of parameters
for returned messages while debugging. Move your mouse pointer over a message checkbox
for a message description.
a. Click the Advanced button to display the entire list of message categories when bugs are
raised. Select the checkboxes corresponding to the message types you would like to
receive.
Each message category is enabled by default. Click the Simple button to minimize this
area and hide the available message categories.
b. Click the All Messages button to select all the message categories.
c. Click the No Messages button if you do not want to select any of the message categories.
6. Click the Apply button to save the changes you have applied within this screen.
7. Click the Revert button to revert back to the last saved configuration.
Configuring a ping
The switch can verify its link with other switches and associated MUs by sending ping packets to
the associated device. Use a ping to test the connection between the switch and IP destinations
you specify. For each ping packet transmitted, statistics are gathered for the round-trip time (RTT)
between the switch and its destination. The RTT is the time (in milliseconds) for a ping packet to
travel from the switch to its target destination and back again. This number can vary significantly
due to the random nature of packet routings and random loads on the switch and its destination.
To view the switch’s existing ping configuration:
1. Select Diagnostics > Ping from the main menu.