Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 204)

190 Brocade Mobility RFS7000-GR Controller System Reference Guide
53-1001944-01
Viewing Access Port Information
4
1. Select Network > Access Port Radios from the main menu tree.
2. Click the Smart RF tab.
3. The following Smart RF details are displayed:
MAC Address Displays the Media Access Control (MAC) Address of each of the APs in the table.
Index Displays the numberical identifier assigned to each detector AP used in Smart RF
calibration.
AP Name Displays the names assigned to each of the APs. The AP name can be configured
on the Access Port Radios Configuration page.
Type Displays the radio type of the corresponding APs.
Available type are:
•
802.11a
•
802.11an
•
802.11b
•
802.11bg
•
802.11bgn
Antenna Gain(dBi) Displays the current antenna gain value in dBi for each Access Port.
Coverage Rate(Mbps) Displays the current coverage rate for each Access Port based on the Smart RF
settings.
Is Detector Displays whether or not an Acces Port is a detector or not.Detector status is
determined through Smart RF based on coverage and location of other APs in the
network.
Lock Detector Displays whether or not each Access Port is locked in detector status.
Lock Channel Displays whether or not each Access Port is locked to a specific channel.
Lock Power Displays whether or not each Access Port is locked to a specific power level.