Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 295)

Brocade Mobility RFS7000-GR Controller System Reference Guide 281
53-1001944-01
Layer 3 Mobility
5
1. Select Services > Redundancy from the main menu tree
The Redundancy screen displays with the Configuration tab selected
2. Configure redundancy settings using the Command Line Interface or the using the Web UI as
described in Chapter , Configuring redundancy settings.
3. Add any redundancy group members using the Command Line Interface or using the Web UI as
described in Chapter , Configuring redundancy group membership.
4. On the Configuration tab, check the Enable Redundancy checkbox and then check the Enable
Cluster GUI box.
5. Click the Apply button to enable the Cluster GUI feature.
6. Once Cluster GUI is enabled a Switch field will be available in many of the Access Port and
mobile unit related screens. The Switch field is displays which cluster members the APs and
MUs are associated with identified by their IP address.
NOTE
When accessing the switch Web UI through a NATed interface the Cluster GUI features will only be
accessible if TCP ports 80 and 161 are opened on the router or gateway.
Layer 3 Mobility
Refer to the following sections to configure Layer 3 Mobility:
• Configuring Layer 3 Mobility
• Defining the Layer 3 peer list
• Reviewing Layer 3 peer list statistics