Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 323)

Brocade Mobility RFS7000-GR Controller System Reference Guide 309
53-1001944-01
AP intrusion detection
6
AP intrusion detection
Use the Access Point Detection menu options to view and configure the detection of other Access
Points. The Access Point Detection screen consists of the following tabs:
• Enabling and configuring AP detection
• Authorized APs
• Unauthorized APs (AP reported)
• Unauthorized APs (MU reported)
• AP containment
Enabling and configuring AP detection
Use the Configuration screen to allow the switch to detect potentially hostile Access Points, set the
number of detected APs allowed and define the timeout and threshold values used for detection.
The switch can enable both Access Ports and MUs to scan and detect Access Points within the
switch managed network. Continually re-validating the credentials of associated devices reduces
the possibility of an Access Point hacking into the switch managed network.
To configure AP Detection:
1. Select Security > Access Port Intrusion Detection from the main menu.
2. Select the Configuration tab.