Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) User Manual
Page 51
Brocade Mobility RFS7000-GR Controller System Reference Guide
37
53-1001944-01
Auto installation
2
The "enables" are cleared using the no autoinstall
URLs and the version string are stored in the configuration file as text and can be cleared using an
empty pair of double quotes to denote the blank string. In the following example, define the three
URLs and the expected version of the image file, then enable all three features for the auto install.
RF Switch(config)#autoinstall config url
ftp://ftp:[email protected]/RFSwitch/config
RF Switch(config)#autoinstall cluster-config url
ftp://ftp:[email protected]/RFSwitch/cluster-config
RF Switch(config)#autoinstall image url
ftp://ftp:[email protected]/RFSwitch/images/RFS7000-GR.img
RF Switch(config)#autoinstall image version 4.1.0.0-040GR
RF Switch(config)#autoinstall config
RF Switch(config)#autoinstall cluster-config
RF Switch(config)#autoinstall image
RF Switch(config)#show autoinstall
feature enabled URL
config yes ftp://ftp:[email protected]/RFSwitch/config
cluster cfg yes ftp://ftp:[email protected]/RFSwitch/cluster-config
image yes ftp://ftp:[email protected]/RFSwitch/images/RFS7000-GR.img
expected image version 4.1.0.0-040GR
Once again, for DHCP option based auto install the URLs is ignored and those passed by DHCP are
not stored.
Whenever a string is blank it is shown as --not-set--.