Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 231)

Brocade Mobility RFS7000-GR Controller System Reference Guide 217
53-1001944-01
Configuring access ports
4
Configuring Adaptive AP firmware
Refer to the AP Firmware tab to view the Access Port and Adaptive AP firmware image associated
with each adopted Access Port or Adaptive AP. The screen allows you to update the firmware image
for Adaptive APs that associate with the switch.
To view AP firmware information:
1. Select Network > Access Port from the main menu tree.
2. Click the AP Firmware tab.
1. Enable or disable Adaptive AP Automatic Update (AAP Automatic Update).
2. View the firmware information displayed per Adaptive AP type with the following data:
3. To add a new AP firmware image, click the Add button. For information on adding a new AP
firmware refer to “Adding a new AP firmware image” on page 218.
4. To edit the details of an AP firmware image, highlight an AP image type and click the Edit
button. For information on adding a new AP firmware refer to “Editing an existing AP firmware
image” on page 218.
AAP Automatic Update Check this box to enable automatic update of Access Port or Adaptive AP firmware
when an Access Port or Adaptive AP associates with the switch. The AP image file
used for automatic update are specified in the AP Image Upload Table below.
AP Image Type The AP image type is the model of Access Port or Adaptive AP which the firmware is
used with.
AP Image File Displays the filename of the image file associated with the AP Image Type.