Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 317)

Brocade Mobility RFS7000-GR Controller System Reference Guide 303
53-1001944-01
Locationing
5
Configuring Aeroscout parameters
To configure the switch to work with an external Aeroscout RTLS engine:
1. .Services > RTLS from the main menu tree.
2. Select the Aeroscout tab.
3. Check the Enable checkbox to globally enable Aeroscout RTLS support on the switch.
This takes effect immediately when the box is checked.
4. Enter the Multicast MAC Address used for all Aeroscout tags to send updates via multicast to
the MAC address specified. Typically the MAC address will start with 01-0C-CC-XX-XX-XX.
NOTE
To use the onboard SOLE engine to locate Aeroscout tags, site parameters, AP location (Command
Line Interface only) and Zone configuration (optional, Command Line Interface only) must be
configured.
5. Click the Apply button to save the Multicast MAC Address value.
6. Click the Revert button to cancel any changes made within Multicast MAC Address value and
revert back to the last saved configuration.
7. If the Multicast MAC Address is configured and Aeroscout support is enabled the following
information will be displayed:
IP Address Displays the IP address of the external Aeroscout RTLS engine.
Port Displays the port number which the switch uses to connect to the external
Aeroscout RTLS engine.
No. of RX Msgs Displays the number of messages received by the switch from the external
Aeroscout RTLS engine.