Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 61)

Brocade Mobility RFS7000-GR Controller System Reference Guide 47
53-1001944-01
Viewing switch port information
3
NOTE
On a Brocade Mobility RFS7000-GR Controller, the MAC address for the me1 port changes when the
switch firmware is updated to the 1.3 version. This addresses an issue where the switch MAC
address and ge1 interface shared the same MAC address in previous versions.
3. Select a port and click the Edit button to modify the port configuration. For additional
information, see “Editing the port configuration” on page 47.
Editing the port configuration
To modify the port configuration:
1. Select a port from the table displayed within the Configuration screen.
2. Click the Edit button.
Name Displays the current port name. On the Brocade Mobility RFS7000-GR Controller,
the available ports are named as follows:
Brocade Mobility RFS7000-GR Controller: ge1, ge2, ge3, ge4, me1
Aggregation
Membership The Aggregation Membership value displays the channel group the port is a
member of.
MAC Address Displays the port’s MAC Address. This value is read-only, set at the factory and
cannot be modified.
Admin Status Displays whether the port is currently Up or Down.
Speed Displays the current speed of the data transmitted and received over the port.
Duplex Displays the port as either half or full duplex.
Medium Type The Medium Type value displays the physical connection type of the port. Medium
types are:
•
Copper: Used on RJ-45 Ethernet Ports
•
Optical: Used on Fiber Optic Gigabit Ethernet Ports