Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 232)

218 Brocade Mobility RFS7000-GR Controller System Reference Guide
53-1001944-01
Configuring access ports
4
5. To delete an existing AP firmware image, highlight an AP image type and click the Delete
button.
Adding a new AP firmware image
To modify the AP Firmware Image settings:
1. Select Network Setup > Access Port from the main menu tree.
2. Click the AP Firmware tab.
3. Click the Add button to display a screen to configure the AP Image Type and AP Image File.
4. Specify the AP Image Type.
5. Specify the AP Image File. You can browse the switch filesystems using the browser icon. AP
images must be on the flash, system, nvram or usb filesystems in order for them to be
selected.
6. Click the OK button to save the changes and return to the AP Firmware tab.
Editing an existing AP firmware image
To modify the AP Firmware Image settings:
1. Select Network Setup > Access Port from the main menu tree.
2. Click the AP Firmware tab.
3. Select an AP Image Type from the AP Image Upload table.
4. Click the Edit button to display a screen to change the AP Image Type or AP Image File.
5. Modify the AP Image Type as necessary.