Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 331)

Brocade Mobility RFS7000-GR Controller System Reference Guide 317
53-1001944-01
AP intrusion detection
6
1. Select Security > Access Port Intrusion Detection from the main menu tree.
2. Click on the AP Containment tab.
The AP Containment screen is divided into two sections, configuration and rogue AP information.
3. To enable the AP containment feature, check the Enable Containment checkbox and specify a
Containment Interval between 20 and 5000 milliseconds. The Containment Interval field
determines the interval after which broadcast 802.11 de-authentication messages will be
sent.
4. When the containment feature has been enabled and a Containment Interval has been set,
click the Apply button to enable the feature and save the interval value.
5. Click the Revert button to cancel any changes made within the screen and revert back to the
last saved configuration.
6. The rogue AP table displays the following information about known rogue APs:
7. To manually add a rogue AP to the table, click the Add button and enter the MAC address of
the known rogue AP.
8. To remove an AP from the rogue AP table, select that AP and click the Delete button.
Index A unique numerical ID assigned by the switch for each of the known rogue APs.
Rogue BSS Mac Display a list of all know Rogue BSS MAC Addresses known to the switch.
Number of Finders Displays the number of detector APs that have found each of the specified Rogue
APs.
Channel Displays the channels that each of the known Rogue APs are broadcasting on.