Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 83)

Brocade Mobility RFS7000-GR Controller System Reference Guide 69
53-1001944-01
Configuring automatic updates
3
2. Refer to the Switch Configuration field to enable and define the configuration for automatic
configuration file updates. If enabled, the located (updated) configuration file will be used with
the switch the next time the switch boots.
NOTE
In addition to the Protocols listed, on the Brocade Mobility RFS7000-GR Controller, users can also
auto-update using USB or Compact Flash.
3. Refer to the Redundancy Configuration field to enable and define the configuration for
automatic cluster file updates.
4. Refer to the Firmware field to enable and define the configuration for automatic firmware
updates. If enabled, the located (updated) switch firmware is used with the switch the next
time the switch boots.
Enable Select the Enable checkbox to allow an automatic configuration file update when a
newer (updated) file is detected (upon the boot of the switch) at the specified IP
address.
IP Address Define the IP address of the server where the configuration files reside. If a new
version is detected when the switch is booted, it is uploaded to the switch and
used upon the next boot of the switch.
User ID Enter the User ID required to access the FTP or TFTP server.
File Name (With Path) Provide the complete and accurate path to the location of the configuration files on
the server. This path must be accurate to ensure the most recent file is retrieved.
Protocol/Device Use the Protocol drop-down menu to specify the SFTP or resident switch FLASH
medium used for the file update from the server. FLASH is the default setting.
Password Enter the password required to access the server.
Enable Select the Enable checkbox to allow an automatic cluster file update when a new
(updated) file is detected (upon the boot of the switch) at the specified IP address.
IP Address Define the IP address of the server where the cluster files reside. If a new version
is detected when the switch is booted it will be uploaded to the switch and used
upon the next boot of the switch.
User ID Enter the User ID required to access the FTP or TFTP server.
File Name (With Path) Provide the complete and accurate path to the location of the cluster files on the
server. This path must be accurate to ensure the most recent file is retrieved.
Protocol/Device Use the Protocol drop-down menu to specify the SFTP or resident switch FLASH
medium used for the file update from the server. FLASH is the default setting.
Password Enter the password required to access the server.
Enable Select the Enable checkbox to allow an automatic firmware update when a new
(updated) version is detected (upon the boot of the switch) at the specified IP
address.
IP Address Define the IP address of the server where the firmware files reside. If a new version
is detected when the switch is booted it will be uploaded to the switch and used
upon the next boot of the switch.
User ID Enter the User ID required to access the SFTP server.