Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 199)

Brocade Mobility RFS7000-GR Controller System Reference Guide 185
53-1001944-01
Viewing Access Port Information
4
Bandwidth information displays per radio with the following data:
Configuring radio groups for MU load balancing
In order to do MU load balancing, radios must be grouped. Usually, two radios with similar
characteristics and geographically close to each other can be grouped together.
By default, a radio is not in any group and the load balancing algorithm would not apply to it.
To configure a group of radios together:
1. Select Network > Access Port Radios from the main menu tree.
2. Go to the Configuration tab.
3. Select a radio you wish to add to a group and click the Edit button.
4. Enter the Group ID for the group you wish to add the selected radio to.
Index The Index is the numerical index (device identifier) used with the device radio. Use
this index (along with the radio name) to differentiate the radio from other device
radios.
Description The displayed name is the name used with the device radio. Use this name (along
with the radio index) to differentiate the radio from other device radios.
QoS Weight Displays the Quality of Service weight for the AP. The default value for the weight is
1. AP QoS will be applied based on the QoS weight value with the higher values
given priority.