Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 162)

148 Brocade Mobility RFS7000-GR Controller System Reference Guide
53-1001944-01
Viewing and configuring switch WLANs
4
3. Select a item from the Exclude List’s List Name field and click the Edit button (within the
Configured WLANs field).
4. Map the selected list item with as many WLANs as needed (be selecting the WLAN’s
checkbox). Use the Select All button to associate each WLAN with the selected list item.
5. To remove the WLAN Mappings, select the Deselect All button to clear the mappings.
6. Refer to the Status field for a display of the current state of the requests made from the applet.
Requests are any “SET/GET” operation from the applet. The Status field displays error
messages if something goes wrong in the transaction between the applet and the switch.
7. Click OK to save and add the new configuration and close the dialog window.
8. Click Cancel to close the dialog without committing updates to the running configuration.
NAC configuration examples using the switch CLI
The following are NAC include list, exclude list and WLAN configuration examples using the switch
CLI interface:
Creating an include list
Since few devices require NAC, Brocade recommends using the "bypass-nac-except-include-list"
option. Refer to the commands below to create a NAC Include List:
1. Create a NAC include list.
RF Switch (config-wireless) #client include-list Desktop
RF Switch (config-wireless-client-list) #
NOTE
The instance changes from
(config-wireless)
to
(config-wireless-client-list)
.