Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 403)

Brocade Mobility RFS7000-GR Controller System Reference Guide 389
53-1001944-01
Configuring IPSec VPN
6
4. Click the IP Range tab to view the following:.
5. Click the Edit button (within the IP Range tab) to modify the range of existing IP addresses
displayed.
6. Select an IP address range index and click the Delete button to remove this range from those
available within the IP Range tab.
7. To add a new range of IP addresses, click the Add button (within the IP Range tab) and define
the range in the fields provided. Click OK when completed to save the changes.
8. Click Cancel to disregard the changes and revert to the last saved configuration.
Configuring IPSEC VPN authentication
If IKE is not used for establishing security associations, there is no negotiation of security
associations. Consequently, the configuration information in both systems must be the same for
traffic to be processed successfully by the IPSec resource. Select the Authentication tab to define
the credential verification mechanisms used with the IPSEC VPN configuration.
To define the IPSEc VPN authentication configuration:
Index Enter the index assigned to the range of IP addresses displayed in the Starting and
Ending IP Address ranges. This index is used to differentiate the index from others
with similar IP addresses.
Starting IP Address Enter the numerical IP address used as the starting address for the range defined.
If the Ending IP address is left blank, only the starting address is used for the
remote destination.
Ending IP Address Enter a numerical IP address to complete the range. If the Ending IP address is
blank, only the starting address is used as the destination address.