Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 329)

Brocade Mobility RFS7000-GR Controller System Reference Guide 315
53-1001944-01
AP intrusion detection
6
4. The Number of Unauthorized APs is simply the sum of all of Unapproved Radio MAC Addresses
detected.
5. If a radio’s MAC address is listed incorrectly, highlight the MAC Address and click the Allow
button.
6. Assign an Index and define the required device address information to move the device into
the list of approved Access Point MAC addresses. The number of Unapproved APs updates
accordingly as devices are added and removed..
7. Click the Export button to export the contents of the table to a Comma Separated Values (CSV).
Unauthorized APs (MU reported)
Use the Unauthorized APs (MU Reported) tab to review unapproved Access Points detected by
associated MUs. The criteria for Access Point approval was defined using the Security > Access
Port Intrusion Detection > Configuration screen, using the values defined within the MU Assisted
Scan field.To view unauthorized Access Points detected by switch radio associated MUs:
1. Select Security > Access Port Intrusion Detection from the main menu tree.
2. Click on the Unauthorized APs (MU Reported) tab.
ESSID Displays the ESSID of each Unapproved AP. These ESSIDs are device ESSIDs
observed on the network, but have yet to be added to the list of Approved APs and
are therefore interpreted as a threat. If an ESSID displays on the list incorrectly,
click the Allow
button and add the ESSID to a new Allowed AP index.
Rogue-detected on wire