Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 164)

150 Brocade Mobility RFS7000-GR Controller System Reference Guide
53-1001944-01
Viewing associated MU details
4
3. MUs not NAC authenticated use RADIUS for authentication. To configure the WLAN’s RADIUS
settings:
a. Configure the RADIUS server’s IP address.
RF Switch(config-wireless) #wlan 1 RADIUS-server primary 192.168.1.30
RF Switch(config-wireless) #
b. Configure the server’s RADIUS Key
RF Switch(config-wireless) #wlan 1 RADIUS-server primary RADIUS-key
my-rad-secret
RF Switch(config-wireless )#
c. Configure the secondary RADIUS server’s IP address.
RF Switch(config-wireless) #wlan 1 RADIUS-server secondary 192.168.1.40
RF Switch(config-wireless) #
d. Configure the secondary server’s RADIUS Key.
RF Switch (config-wireless) #wlan 1 RADIUS-server secondary RADIUS-key
my-rad-secret-2
RF Switch (config-wireless) #
4. Configure the NAC server’s timeout and re-transmit settings. The timeout parameter
configures the duration for which the switch waits for a response from the RADIUS server
before attempting a retry. This is a global setting for both the primary and secondary server.
The re-transmit parameter defines the number of retries a switch attempts before
dis-associating the MU.
RF Switch(config-wireless) #wlan 1 nac-server timeout 30 retransmit 10
RF Switch(config-wireless) #
5. Configure WLAN for EAP authentication and define the encryption type.
RF Switch(config-wireless) #wlan 1 authentication-type eap
RF Switch(config-wireless) #wlan 1 encryption-type wep128
RF Switch(config-wireless) #wlan 1 ssid wlan-1
Viewing associated MU details
The Mobile Units screen displays read-only device information for MUs interoperating with the
switch managed network. The Mobile Units screen consists of the following tabs:
• Viewing MU status
• Configuring Mobile Units
• Viewing MU statistics
• Viewing voice statistics
Viewing MU status
To view MU Status is detail: