Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 327)

Brocade Mobility RFS7000-GR Controller System Reference Guide 313
53-1001944-01
AP intrusion detection
6
1. Select Security > Access Port Intrusion Detection from the main menu.
2. Select the Authorized/IgnoredAPs tab.
3. The Authorized/Ignored APs table displays the following information:
4. The Number of Approved APs is simply the sum of all of approved Access Point MAC Addresses
detected.
5. Click on the Export button to export the contents of the table to a Comma Separated Values
file (CSV).
BSS MAC Address Displays the MAC Address of each approved AP. These MAC addresses are Access
Points observed on the network meeting the criteria (MAC and ESSIDs) of allowed
APs.
Reporting Radio Displays the numerical value assigned to the radio used with the specific device
MAC Address and SSID listed for this approved AP.
Channel Displays the channel the approved AP is currently transmitting on. If this device is
operating on a channel not frequently used within your network segment, perhaps
the device is correctly defined as an approved AP.
Last Seen ( Seconds) Displays the time (in seconds) the approved AP was last seen on the network.
ESSID Displays the SSID of each approved AP.
Authorized/Ignored Displays whether traffic from each listed AP is either allowed or ignored by the
switch.