Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 454)

440 Brocade Mobility RFS7000-GR Controller System Reference Guide
53-1001944-01
Configuring Access Control
7
1. Select Management Access from the main menu tree.
2. Refer to the Current Status field to review the following read-only information:
NOTE
The Apply and Revert functions are greyed out within the Management Access screen, as this screen
has no configurable parameters for the user to update and save.
Configuring Access Control
Refer to the Access Control screen to allow/deny management access to the switch using the
different protocols (HTTP, HTTPS, Telnet, SSH or SNMP) available to users. Access options are
either enabled or disabled as required. The Access Control screen is not meant to function as an
ACL (in routers or other firewalls), where you can specify and customize specific IPs to access
specific interfaces.
To configure access control settings:
Firmware In Use The Firmware In Use value displays the software version currently running on the
switch. Use this information to assess whether a firmware update would improve
the switch feature set and functionality.
Log Output The Log Output value displays the target location for log files output by the switch.