Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 402)

388 Brocade Mobility RFS7000-GR Controller System Reference Guide
53-1001944-01
Configuring IPSec VPN
6
5. Refer to the Status field for the current state of the requests made from applet. This field
displays error messages if something goes wrong in the transaction between the applet and
the switch.
6. Click OK to use the changes to the running configuration and close the dialog.
7. Click Cancel to close the dialog without committing updates to the running configuration.
Defining the IPSec VPN remote configuration
Use the IPSec VPN Remote tab to configure the DNS and/or WINS Servers used to route packets to
the remote end of the IPSec VPN tunnel. The Remote tab is also used for defining the IP address
range used within the IPSec VPN tunnel and configuring the authentication scheme for user
permissions within the IPSec VPN tunnel.
To define the IPSEc VPN’s remote configuration:
1. Select Security > IPSec VPN from the main menu tree.
2. Click the Remote tab.
3. Refer to the Configuration field to define the following:
DNS Server Enter the numerical IP address of the DNS Server used to route information to the
remote destination of the IPSec VPN.
WINS Server Enter the numerical IP address of the WINS Server used to route information to the
remote destination of the IPSec VPN.
Apply Click Apply to save any updates made to the screen.
Revert Click the Revert button to disregard changes and revert back to the last saved
configuration.