Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 359)

Brocade Mobility RFS7000-GR Controller System Reference Guide 345
53-1001944-01
Configuring firewalls and access control lists
6
9. If mark is selected from within the Operations drop-down menu, the Attribute to mark field
becomes enabled. If necessary, select the 802.1p (0 - 7) or TOS(0 - 255) checkbox and define
the attribute receiving priority with this ACL mark designation.
10. From within the Filters field, modify (if necessary) the Source Mask Length from the drop-down
menu.
The source is the source address of the network or host in dotted decimal format. The
Source-mask is the network mask.
11. Use the Source Address field to revise (if necessary) the IP address where the packets are
sourced.
NOTE
If an Extended IP ACL is used, a Destination Wildcard/Mask and Destination Address are required.
12. Refer to the Status field for the state of the requests made from applet. This field displays error
messages if something goes wrong in the transaction between the applet and the switch.
13. Click OK to use the changes to the running configuration and close the dialog.
14. Click Cancel to close the dialog without committing updates to the running configuration.
Configuring Layer 2 firewall
To review Layer 2 firewall rules:
1. Select Security > Wireless Firewall from the main tree menu.
2. Click the Configuration tab.
3. Click the L2 tab.
4. The L2 tab contains the following information: