Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 290)

276 Brocade Mobility RFS7000-GR Controller System Reference Guide
53-1001944-01
Configuring switch redundancy & clustering
5
2. Select the Member tab.
3. Refer to the following information within the Member tab:
IP Address Displays the IP addresses of the redundancy group member.
Status Displays the current status of this group member. This status could have the
following values:
•
Configured - The member is configured on the current wireless service
module.
•
Seen - Heartbeats can be exchanged between the current switch and this
member.
•
Invalid - Critical redundancy configuration parameter(s) of the peer (heartbeat
time, discovery time, hold time, Redundancy ID, Redundancy Protocol version
of this member) do not match this switch’s parameters.
•
Not Seen - The member is no more seen by this switch.
•
Established - The member is fully established with this current module and
licensing information already been exchanged between this switch and the
member.
•
Unknown - No status information could be obtained.
Last Seen Displays the time when this member was last seen by the switch.
AP Adoption Count Displays the number of Access Ports adopted by this member.
AAP Adoption Count Displays the number of Adaptive APs adopted by this member.
AP License Count Displays the number of Access Port licenses installed on this member.
AAP License Count Displays the number of Adaptive AP licenses installed on this member.
Mode The Redundancy Mode could be Active or Standby depending on the mode
configuration on the member. Refer to the Configuration screen to change the
mode.