Meridian America Link/Customer Controlled Routing - Manual (Page 53)

Chapter 3: Overview of Customer Controlled Routing 35
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Option 11 systems support an SDI port on any of the following cards:
Ñ the CPU/CONF card (NTAK01AB)
Ñ the SDI/DCH card (NTAK02AB)
Ñ the TDS/DTR card (NTAK03AB)
¥ limited-distance modems for communications facilities if the IPE
Module or Application Module is greater than 15 m (50 ft) from the
Meridian 1 or peripheral devices, such as terminals and printers
An Application Equipment Module (AEM), if present, must be installed in
one of the following configurations:
¥ as a stand-alone AEM column (the configuration used with Meridian
SL-1 style cabinets)
¥ as a module in a Meridian 1 column
Refer to Application Equipment Module Installation Guide
(NTP 553-3201-200) for AEM installation procedures.
The following table shows hardware supported for the Meridian Link and
CCR applications.
Table 3
Hardware supported for Meridian Link and CCR
Application MVME147 AM MVME167 AM IPE Module
CCR 3C No Yes Yes
Meridian Link 5C and CCR 3C No Yes* Yes
* This configuration is supported provided it is Ethernet accessible.
Upgrading the MVME147 AM with an MVME167 card is not equivalent to
an MVME167 AM therefore Meridian Link 5C using TCP/IP transport is
not supported.